ECN publicatie: facebook
Titel:
Fast and easy single step module assembly for back-contacted c-si solar cells with conductive adhesives
 
Auteur(s):
Bultman, J.H.; Eikelboom, D.W.K.; Kinderman, R.; Tip, A.C.; Tool, C.J.J.; Weeber, A.W.; Nieuwenhof, M.A.C.J. van den; Schoofs, C.; Schuurmans, F.M.
 
Gepubliceerd door: Publicatie datum:
ECN Zonne-energie 1-5-2003
 
ECN publicatienummer: Publicatie type:
ECN-RX--03-019 Conferentiebijdrage
 
Aantal pagina's: Volledige tekst:
4 Download PDF  (34234kB)

Gepresenteerd op: 3rd World Conference on Photovoltaic Energy Conversion, Osaka, Japan, 11-18 mei 2003.

Samenvatting:
The simplest way to produce a module of crystalline silicon solar cellsis with back-contacted cells that are glued on an interconnection foil using conductive adhesives. This foil also serves as environmental barrier at the rear of the module. The conductive adhesive is tuned to cure in the same cycle as the encapsulant. It is possible to interconnect the cells without any additional temperature curing in a single lamination step. The interconnection foil can be made for an acceptable cost price, as is shown in the paper. The savings in labor, a higher efficiency, and a yield increase will lead to a lower cost price for such a module. First results show that a module produced in a single step leads to similar fill factors as soldered modules.


Terug naar overzicht.